Ferrari Life Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter · #1 ·
These questions may be the same for 308s as well.I'm sure the door lock pulls and trim rings come from some mass produced car. does anyone know which? Also I'm pretty sure the condition at the gas flip up door in my car can't be factory correct. its metal to metal and the paint has already chipped from last years restoration. I'm guessing a rubber or plastic sleeve. Would someone please take a photo? lastly what would be the correct finish for the gated shifter. Brushed grains in one direction? thanks in advance. see photos
Hood Automotive tire Grille Vehicle Automotive design

Tire Wheel Automotive tire Hood Motor vehicle
 

·
Registered
Joined
·
16 Posts
Discussion Starter · #3 ·
Hey thanks for your reply. Looks like black paint or unfinished metal. I think I'll take mine down to black matte paint and slip a split rubber hose over bar so it doesn't keep chipping. thanks again.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top