Ferrari Life Forum banner
1 - 3 of 3 Posts

· Registered
28 Posts
Discussion Starter · #1 ·
Hello from snowy DC!

Have visited this subject of cam re-profiling, but am now moving to actually do it. Both WebCam and Dema Elgin seem quite good at this and know what they are talking about, but was curious what experiance if any folks have had with the hard welding cam reprofiling.

I have the stock Kjet cams in now, and want to take more advantage of the Webers. Judging from 348 and 355 cam profiles, will probably keep my current exhaust duration and run the intake up to 255 - 260. Both WebCam and Elgin say anything more on a 4v is too much for the street.

Any advice welcome.
best to all
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.