Ferrari Life Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Not sure us this is a good place to post this but here goes. I am from X-Clusive Exhaust in Ottawa Canada. We were contracted by Ferrari Quebec to make a set of headers for a 330. The issue is our guy went and bent 10 sets of pipes and we only needed 1. If there is anyone interested in headers for the 330 please let me know we have a few sets we can make.

General specs:
pipes mandrel bent 304
flanges are 7mm stainless
tig and sanded mig welds used
ceramic coated for heat protection
Cost $4200.00 CDN

Thank you
 

·
Administrator
Joined
·
15,140 Posts
Not sure us this is a good place to post this but here goes. I am from X-Clusive Exhaust in Ottawa Canada. We were contracted by Ferrari Quebec to make a set of headers for a 330. The issue is our guy went and bent 10 sets of pipes and we only needed 1. If there is anyone interested in headers for the 330 please let me know we have a few sets we can make.

General specs:
pipes mandrel bent 304
flanges are 7mm stainless
tig and sanded mig welds used
ceramic coated for heat protection
Cost $4200.00 CDN

Thank you
Have you posted it up on tomyang.net ?
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
Actually I have had two emails from Tom. I just need to get the word out.

FYI we will also be manufacturing headers for the 355/360/430 in the near future.
 
1 - 3 of 3 Posts
Top