Ferrari Life Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter · #1 ·
Hello everyone, :D

I am new on board. I am looking at getting a M550 very soon. I have allready ordered the workshop manual but I am looking for some kind of software to be able to service my Ferrari.
My question is the following: Is there a software out there capable of translating the error codes / messages and able to reset the inspection intervals that I can load into a laptop? :stupid:
I presently use something similar for my Audi from RossTech but is there something for Ferraris ? I do not want to get to Ferrari and buy an SD2 system. :nuts:
Thanks for all the replies,
DG
 

·
Registered
Joined
·
476 Posts
First, welcome!

As far as being able to get to the codes that's been a bit of a contention with many Ferrari and other marquee car owners. Ferrari doesn't provide that information. And I don't know of anyone who's been able to get hold of it.

Congress here in the U.S. is currently working on legislation to make manufacturers reveal these codes. http://civilliberty.about.com/b/a/072888.htm

Until this happens we'll just have to try and track down the information ourselves. If you find it let us know! Or, I could be wrong and someone here might have found it and I just haven't seen the post. If it has been found the thread should be made a sticky.


http://seattlepi.nwsource.com/national/164817_gearheads15.html
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top